Hi Ferg
I fitted the cable then trimmed of the surplus, it still leaves you adjustment
at the turbo end, for when the cable stretches, I also fitted a Ali cover over
the motor to stop any interference with nearby cables,
regards
ivor
---- Fergus Kyle <VE3LVO@rac.ca> wrote:
> Cheers,
> Ferg on the beg again.....
> I am trying to maximize the tiny instrument panel volume and have
> come across my nemesis, the small rotating disc housing the turbo control
> cable on the motor sitting on the centre mount - quite starboard. To mount
> the panel, I have carved out the base of the panel but now observe that the
> 2inches or so (5-6cm) excess to the disc would appear to flail about when
> the controller is adjusting the gate. Since this was all mounted according
> to the Europa instructions I suspect I'm not the only one.
> Thing is, can I nip a bit off what appears to be excess cable? ...
> or will I find somewhere down the build I shouldn't have touched its
> precious self? That trim would give me a couple more cubic inches of space
> for other devices.
> What did you do?
> Ferg
> Soobs and Jabs need not apply
|