Dead easy. We used little wire 'u' clamps available from any DIY place.
After about 200 hours on a very bumpy strip I'm thinking of maybe adding
another (10 minute job) but it's been no problem. There will be all the
details in the archives.
Cheers
Rick Morris
G-RIKS Tri 912S
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of craig bastin
Sent: 14 April 2009 12:50
Subject: RE: Europa-List: Bungee Install
--> <craigb@onthenet.com.au>
I believe some of the guys also ran the bungee as a series gaint rubber
bands, which allowed each one to be adjusted, and tension was controled by
adding or removing as required. Not sure how the ends were fixed though.
craig
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of danbish
Sent: Tuesday, 14 April 2009 3:34 PM
Subject: Europa-List: Bungee Install
Hi All,
I remember seeing something on here about a slight mod to the installation
of the bungee cord, something about cutting it into 2 pieces? Can't find
anything on it now, just wondering if there's anyone with more info on this
and what the benefit is of doing it.
Thanks,
Dan
Visit - www.EuropaOwners.org
Checked by AVG - www.avg.com
17:56:00
|