On May 15, 2009, at 9:58 AM, Frans Veldman wrote:
> It seems that the only error the factory made was to cut the port side
> of the front half at the wrong angle.
>
> About the pictures:
> Keep in mind that this is preliminary fitting. Even the anchor nuts
> are
> not attached, the bolts are just inserted through the holes to keep
> everything temporary in place. (Should have used cleco's for this,
> but I
> already drilled the holes before I discovered that these fairings are
> wonky).
>
> The white shaft you see is my 2 inch nose wheel shaft extension, to
> allow for a larger prop.
Frans,
Nice crisp and clear explanation of a simple solution to the nose gear
fairing.
And your prop looks great...[at first glance, I thought I saw some de-
icing boots on its leading edge...:-) ].
May I ask what your prop diameter is?
Fred
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|