Hi,
Just a minor point to check I've not done anything wrong.
I'm fitting Mod 70 from new rather than replacing. The instructions say use an
AN3-10A bolt to hold the TP18B component in place. If I do this then I have
about 3-4mm of unthreaded shaft pointing out from the other side. The
instructions
then say use an AN960-10L washer behind the nut but this is not thick enough
to get over the unthreaded shaft. I believe the bolt I have is the correct
item and I could obviously pad it out with washers but why not use an AN3-9A
or something OR have I done something wrong?
Regards,
Phil
Visit - www.EuropaOwners.org
|