Hi Fred
I used a couple of rivnuts per side on the cover plates, Haven't had problems
with door flexing, Easy access if needed to lock mechanism,
regards
Ivor
> On another note, I'm fitting my homemade splash mold cover plates
> over the cutouts for the latch mechanisms and see that the manual
> calls for them to be Reduxed in place. Doing so prevents access to the
> head of the AN3-12A bolt which secures the exterior door handle. Once
> the cover is glued on, it would appear impossible to remove or
> reinstall the handle, unless a hole (not called for in the manual)
> large enough for a socket is cut in the cover. Although the manual
> states that the purpose of the cover is to strengthen the door frame,
> I'm tempted to secure the cover w/ a few small flathead bolts tapped
> into the frame.
>
> Comments anyone?
>
> Fred
> A194
>
>
>
|