Hi,
To those that have gone before me .......
I'm working on the door latches and getting the shoot bolts (DL06) installed
inside
the DL07 guides. Taking previous advice I'm looking at the dimensions in
the manual and what I actually have in front of me.
I haven't glued the guides in yet but a dry set up shows that my worst case is
on the front door bolts and at worst with the doors latched, I have 10mm of the
parallel section (20mm total) of the DL06 protruding. Is that going to be
enough? I remember reading about this on the forum ages ago but I can't find
the posting in question.
Regards,
Phil
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=281901#281901
|