Kevin,
I hope you had a great trip. You'll have to write about it and submit
it.
Bud Yerly
----- Original Message -----
From: Kevin Klinefelter<mailto:kevann@gotsky.com>
To: europa-list@matronics.com<mailto:europa-list@matronics.com>
Sent: Wednesday, April 28, 2010 8:20 AM
Subject: Re: Europa-List: Europa Monowheel Brake Problem?
=EF=BB
Hi Jeff,
My mono-wheel brake was leaking a bit of fluid and not holding
pressure well. Turned out to be the O-ring seal. We removed the brake
---From the disc and used a rubber tipped compressed air gun to push the
"puck" out of the slave cylinder. Then we saw the o-ring to replace. It
looked like it was leaking from the bleed screw simply because the bleed
screw is the lowest point to drip from.
When the mono is sitting tail down the master cylinder in the tunnel
is at an angle with the filler low. I needed to raise the tail (or
unmount the master cyl) to get the air out.
Messy job eh?
Kevin
http://www.matronics.com/Navigator?Europa-List<http://www.matronics.com/N
avigator?Europa-List>
http://www.matronics.com/contribution<http://www.matronics.com/contributi
on>
|