Good day All,
I am mounting my Sensenich R642N Ground Adjustable prop to the engine flan
ge and wanted to verify with those that have already accomplished this tas
k if I am understanding the mounting procedure.
The spinner flange goes against the engine flange then the large aluminum
mount goes on. These are held by six AN5-15A bolts inserted from the rear
with a dual interlocking washer under the head, then another interlocking
washer under the Nylock nut with all this torqued to 30 ft/lbs in sequenc
e. Then the center adjusting hub and both prop blades are mounted with the
front half of the aluminum mount. These are mounted with another six AN5-
15A bolts with a dual interlocking washer under each head and torqued to
30 ft/lbs.
Am I understanding this correctly? Has anyone used Loctite on any of the
threads? What about safety wire?.....wanted?.......required?
Mike Duane
Europa XS Conventional Gear
Jabiru 3300
Sensenich Prop
|