In my case the flap drive pins engagement comply with the service bulletin on
that
matter but at the portside it is at the limit. So I decide the bring it well
within the limits and I purchased the special bearing housing from Europa
Aircraft.
I have now a problem to remove the original housing and bearing from the x-tube.
The x-tube end was heated with a hot air gun (air of 600 degr. C / 1110 degr.
F) but I could not get any movement of the bearing housing.
Has anybody experience in removeing the bearing housing from the X-tube ? Any
ideas
are welcome.
Kees de Bussy
PH-SBR
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=333147#333147
|