Hi Marcel
I have a bit similar failure. I have a combination
Trio EZ Pilot & Garmin 296. When engaging the
servo to follow the route, it goes to route but 30
degrees to the left.
I noticed if I first switch off the EZ, then
confirm the route again and finally switch on the
EZ, it goes perfectly and follows the specific
route to the final destination.
I contacted Jerry and he told there is a known
software bug (I purchased my EZ 2009).
He kindly asked me to send it to them for a new
software installation but so far I have refused
because I do not want to open my panel for that
minor reason - I can live (fly) with it.
Cheers, Raimo Toivio
Europa XS Mono OH-XRT #417
Updated flight hours: 242,0
37500 Lempaala
FINLAND
p +358-3-3753 777
f +358-3-3753 100
toivio@fly.to
www.rwm.fi
-----Alkuperinen viesti-----
From: zwakie
Sent: Monday, August 15, 2011 9:56 PM
Subject: Europa-List: Navaid servo, full left
aileron
<mz@cariama.nl>
Hi list,
Today I have replaced my Navaid controlhead with a
new Trio EZ Pilot controlhead. All works fine, my
Skyforce IIIC is providing all informatn
perfectly.
I do however have one issue: when engaging the
servo, the servo immediately gives me full left
aileron. This exact same thing happened with the
Navaid controlhead, so as far as I can tell one of
the following coild be wrong:
A) my Navaid servo is not properly functioning;
Trio has offered to look at the servo after I ship
itto them (excellent service from Jerry!)
B) the PWM wire running from the controlhead to
the servo has broke
My guess is that scenario B) is what is wrong,
because this full aileron issue started after
someone has done some work behind the panel.
My question to the list: would a broken PWN wire
indeed result in a full aileron deflection?
Any input is highly appreciated!
Marcel
--------
Marcel
(Classic Tri-Gear PH-MZW - formerly G-BWON)
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=349525#349525
browse
Un/Subscription,
FAQ,
http://www.matronics.com/Navigator?Europa-List
Forums!
List Admin.
|