Thanks to Tim and Graham for help regarding cutting down the Fuel Filler
Tube cover and Tims Aluminium pipe.
Reg
Tony Renshaw
On Wednesday, September 21, 2011, GRAHAM SINGLETON <
grahamsingleton@btinternet.com> wrote:
> Tony
> Tim's aluminium elbow is highly recommended, it stops a lot of the fuel
smell in the cockpit, but make sure all the molding flash is carefully cut
off the Cobra so that the rubber tube jopints sit snuggly and seal to the
Cobra, and the tank stub
> Graham
>
>
> ________________________________
> From: Tim Ward <ward.t@xtra.co.nz>
> To: tonyrenshaw268@optusnet.com.au; europa-list@matronics.com
> Sent: Wednesday, 21 September, 2011 10:56:45
> Subject: Europa-List: Aluminium Fuel Tube
>
> Tony,
> See attachment in fixing the aluminium pipe supplied by me.
> It is purposely too long to allow for different fittings.
> Position the =93cobra=94 first with your splash moulding.
> Don=92t forget to reinforce the skin behind the cobra moulding with 3 lay
ers
of Bid to prevent deforming skin in hot temperatures (Aussie)
> Cut it, the pipe, gradually back , a little at a time until you have the
correct fit.
> The rubber piping at each end allows for mistakes.
> Once it is joined up then do the lay ups to the wall for the cobra.
> Puts some blue foam at the back of the cobra to allow for the shape and
expansion.
>
>
> Cheers,
>
> Tim
>
>
> Tim Ward,
> 12 Waiwetu Street,
> Fendalton,
> Christchurch 8052
> New Zealand
>
> Ph; 03 3515166
> Mob; 0210640221
>
> email; ward.t@xtra.co.nz
>
>
===========
===========
===========
===========
>
>
|