Ramio,
Sounds like a throttle cable to one carb was loose causing the spring to
hold full throttle on the carb while you could vary the other as it was
connected properly.
Bill
A010 Classic Monowheel
----- Original Message -----
From: "Raimo Toivio" <raimo.toivio@rwm.fi>
Sent: Monday, October 03, 2011 12:00 PM
Subject: Re: Europa-List: Re: Heavy In-flight Vibration Riddle
>
> Jet,
>
> you may also guess twice (because you are pilots wife):
>
> - notice that shaking and vibration was not momentary! Every time I tried
> to change powersettings up or down, more or less, an awful trembling came
> back. Maybe I am a bit sensitive (for trembling planes!) but that was
> really alarming.
> - 5400 rpm & 20 inches were in the lowest point of that vibration curve
>
> Cheers, Raimo OH-XRT Finland
>
>
> -----Alkuperinen viesti-----
> From: zwakie
> Sent: Monday, October 03, 2011 5:34 PM
> To: europa-list@matronics.com
> Subject: Europa-List: Re: Heavy In-flight Vibration Riddle
>
>
> Some sort of contamination found it's way into the spinner hole of one of
> the prop blades, preventing full travel for just this blade's pitch?
>
> Jet
>
> (Marcel's wife) [Wink]
>
> --------
> Marcel
> (Europa Classic Tri-Gear PH-MZW)
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=353877#353877
>
>
> browse
> Un/Subscription,
> FAQ,
> http://www.matronics.com/Navigator?Europa-List
> Forums!
> List Admin.
>
>
>
|