Hi, On my exhaust system (912ULS with standard XS fit) should I seal/ lubricate
the joints? By this I mean the 4 ball joints where the top of the exhaust pipes
bolt onto the cylinders and also the other 4 ball joints where the bottom
end of the down pipes fit into the silencer box.
In the build manual there was no reference to doing this so I did not do so -
just
fitted them dry. I now notice that around these joints -mainly the lower
ones held by the springs - there are signs of escaping exhaust gasses - light
grey streaks. If I should be applying a product here I would be grateful for
advice on what product to use and where (in the Uk) to get it!
Cheers, Jon
--------
G-TERN
Classic Mono
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=364070#364070
|