Hi! A heat gun (hot air only) worked for me then a good clout with a hammer
and a chisel on the outer diameter.
Regards
Bob Harrison.
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Richard Lamprey
Sent: 19 February 2012 08:50
Subject: Europa-List: Removing magnetic plug from Rotax 912 gearbox
<lamprey.richard@gmail.com>
Does anyone know the best way to get this plug out? I burred the hexagonal
inset, so hex key (allen key) no longer going to get it out. I have tried
clonking gently with hammer (as per various instructions) to loosen, to no
avail.
My plug replacement is of the new variety that can be removed with a
ring-spanner. Just got to get the old out and check for filings.
Perhaps a left handed thread bolt/screw that self-taps into the burred
inset??
Any ideas welcome.
Richard
Europa 168, Kenya
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=366581#366581
|