Re: Europa-List: trim link rod fouling sevo bellcrank

[craigb <craigb@onthenet.com.au>]

Yes I believe i had the same issue you are describing, when you are at 
full travel
on both the servo and the elevator, the servo is being pushed up by the 
crank.
If that is your issue, mine was resloved by shortening the link rod 
just enough
to prevent the issue. I had to trim a couple of mm from each end of the 
pieces that
screw onto the threaded rod and shorten the rod by the same amount. It 
seemed to do the trick
and it didnt take much to fix it

regards

craig