Rowland,
Had to go back and look it up. Found the picture:
http://www.europaowners.org/main.php?g2_itemId=61995
I had to ream the holes to 16mm to get the proper fit.
Blue skies & tailwinds,
Bob Borger
Europa XS Tri, Rotax 914, Airmaster C/S Prop.
Little Toot Sport Biplane, Lycoming Thunderbolt AEIO-320 EXP
3705 Lynchburg Dr.
Corinth, TX 76208-5331
Cel: 817-992-1117
rlborger@mac.com
On May 12, 2012, at 11:21 PM, Rowland Carson wrote:
I have just profiled the LG02A shock absorber pin support and am about to
re-install
it on the LG02 swinging arm, but first I thought I'd better install the
LG02B bungee cord attachment bar. However, I find that LG02B (which is actually
a length of steel tube) does not readily fit into the hole already made in
LG02A.
Before I start to use my initiative on enlarging the hole slightly, does
anyone have any observations on this? Should it fit nicely as supplied? Is it
supposed to be a drive-in (interference) fit?
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
|