X-mailer: iolo System Shield 10.7.6.60
PS: the normal setting for the manifold pressure gauge is PRESSURE - not
sure why but once you get used to working with this its fine.
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of graeme bird
Sent: 22 July 2012 09:41
Subject: Re: Europa-List: Weight of HPL 3 blade warp drive prop for ref
Well I have fitted to Woodcomp 3000/3W and done a couple of short initial
test flights. The LAA test schedule seems to imply that I might need to
adjust the microswitch positions but the Woodcomp manual says this should
only be done at the factory. Did anyone find it necessary to adjust them and
if so did they do it themselves of get Kevin involved? I guess I am asking
Carl and David.
So far the take off seems much more rapid, but then it seemed to stop
accelerating at just above 60kts and I have to go to climb and put the gear
up. The top end doesnt seem that much faster but then I may not have been
applying full power. Not sure whether to display pressure or HP on the
controller.
--------
Graeme Bird
G-UMPY
Mono Classic/XS FWFD 912ULS/Warp drive FP
Newby: 35 hours
g@gdbmk.co.uk
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=378909#378909
_______________________________________
No infections found in this incoming message Scanned by iolo System ShieldR
http://www.iolo.com
_______________________________________
No infections found in this outgoing message
Scanned by iolo System Shield
http://www.iolo.com
|