Carl
The mod Bruno describes is documented on our web site
(http://www.theeuropaclub.org/wp-content/uploads/2011/12/G-MIME-Vents.pdf).
It is PFA/LAA approved but at present LAA cannot find the paperwork (or even
a number for it).
The ultimate vent is nice (see picture) but expensive.
Ian Rickard G-IANI XS Trigear, 300hours
Europa Club Mods Specialist
e-mail g-iani@ntlworld.com
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Carl Pattinson
Sent: 13 August 2012 00:08
Subject: Europa-List: Fresh air Vents
Hi,
Does anybody have a mod/ design for a vent that can easily be fitted to an
existing installation.
I believe the front screen is a structural component so can't be altered but
presumably the side screens could have a vent installed.
I believe that Spruce and Speciality sells design that can simply be bolted
into a circular hole cut through the Perspex.
For obvious reasons an approved mod would be preferred.
Thanks
Carl Pattinson
G-LABS
_____
No infections found in this outgoing message
Scanned by iolo System ShieldR
http://www.iolo.com
|