There is a "minimum dimension" in chapter 9. It would appear that the
distance from hole to edge must be a good 1.5 times the diameter of the
bolt - which is a standard if I remember correctly. This comes to 7.14
mm for AN3. The manual requires 7.62 mm.
Jan de Jong
On 1/20/2013 3:58 AM, Kyle P wrote:
>
> After the wings were painted the holes on w19/w20 don't allign with
> w18. I couldn't find a value for how much material I can remove from
> the brackets and still be in "limits." I like to avoid sanding down
> into the paint to make room for the brackets.
>
> Also on a side note, the top port for the AOA was filled and painted
> over. Any tricks to clearing out the hole?
>
> Thank you,
> Kyle Phillipson
>
> *
>
>
> *
|