Alan.
Just a thought, your aircraft has a LAA permit, I assume , and if so you
must have an LAA inspector to sign off your re wiring work.
He , the inspector, is the best person to check out these options and
changes. and give you advice
. The forum is a good place for information but in the end it is wise to
have your plans looked over by another independent pair of eyes.
regards
Tim
On 27 February 2013 20:14, Alan Carter <alancarteresq@onetel.net> wrote:
> >
>
> Hi All.
> So 6 amps is OK, i am not a builder so don,t have odd pieces of alloy
> laying around so had to use an old plate i found, i have made my little
> panel and fitted it in place, also made a little CB panel, to connect it
> to. Sometime i will get round to wiring it up,so a couple of questions.
> The switches are 6 amps at 135v AC so i am limiting the Aux power sockets
> to
> 6 amps each by an in line fuse. I am not sure if the switch would take 10
> amps at 12 volts ? 6 or 10 ?
> The usage will be, phone, ipad, inspection lamp, tyre pump,
> I intend to put the 2 x in line fuse on the (live + wires) BEFORE the
> switches,?
>
> The Starter Button, is 6 amps, and power switch also 6 amps, flip the
> switch and the START BUTTON illuminates in RED,then Press for start.
> Does anyone have the Rotary Mag key starter switch, because i need the
> starter relay wire from this switch, i take it that its is single pole so
> just the two wire to be taken over to my new switch, which two.?
>
> This will now give me independent mags, for engine starting.
> Later the Soft Start module this is only 20 minutes to fit if you have
> separate mag switches, its the easy bit.
>
> Alan
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=395212#395212
>
>
|