I've drilled the 7/8" hole in F10 for the tailwheel arm. I used outside calipers
to get the centre the correct 1" above the fuselage bottom skin (that is, the
OUTSIDE of the fuselage) and took care to keep the bore of the hole parallel
to the fuselage bottom. The bottom of the hole finished up just clear of the
curved bottom flange of F10.
The tailwheel arm XTW06 fits into the hole, but will not go far enough forward
for the hole at forward extremity of XTW06 to align with the marked centre 160mm
forward of the front face of F10, because XTW06 binds against the bottom of
F10 & of the fuselage.
Do I need to
(a) enlarge the hole in F10 upwards?
(b) relieve F10 & fuselage at the bottom centre to clear XTW06?
Opinions, please!
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype, Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
|