On Oct 8, 2013, at 10:12 AM, graeme bird wrote:
> if its the airworld one; mine did leak slightly when the tank was up
to the filler. I got in a right pickle when sorting it; forgetting
(alter applying gue) that the five holes have to align, in sender,
gasket, tank and nut ring because although they appear equi-distant they
are actually on three different pitches. I also dropped the ring nut
into the tank and a screw (plonker).
> If I had to do it again, I would buy 5 longer screws and replace the
them one at a time allowing the sender and gasket to be lifted and a
small amount of sealer to be applied from around the top. When replacing
the with the right length screws I would add a small blob to each to
seal the clearance hole and thread.
Excellent suggestions Graeme...thank you...Fred
|