Yes Tony , I mounted a D socket on to the servo body so that I could remove
it for service in the future, its a bugger of a place to get at. The other
end tails go straight to the switch and indicator.
Best of luck
Richard
-----Original Message-----
From: Tony Renshaw
Sent: Wednesday, May 21, 2014 10:32 AM
Subject: Europa-List: Electrical Wiring
Gidday,
I am interested in what is the correct or preferred connector for the small
wires in the RayAllen Servo wire bundles etc., the small dia cabling of many
devices. Im sure there are some better than others, but I currently dont
know any, albeit a ACS catalogue could narrow it down. So far, I have tried
D sub terminals, as they are easy to get and easy to solder. Should I stick
with them??
regards
Tony Renshaw
-----
No virus found in this message.
Checked by AVG - www.avg.com
|