Rowland i recall that the cover plate for the retract lever slot=2C does in
fact hang over the edge on the rear left corner. This will not be seen onc
e the carpet is fitted. Philip George.
Sent from Samsung Mobile
<div>-------- Original message --------</div><div>From: Rowland Carson <row
landcarson@gmail.com> </div><div>Date:19/09/2014 23:25 (GMT+00:00) </div>
<div>To: Europa e-mail list list <europa-list@matronics.com> </div><div>Sub
ject: Europa-List: retract lever slot </div><div>
</div>
I=99ve started marking out the position of the landing gear retract l
ever slot on the top of the tunnel=2C but I=99m worried that it appea
rs rather close to the edge of the top surface at its aft end. If I put the
guide plate on top of where I=99ve marked=2C it protrudes beyond the
edge of the tunnel=2C so it looks as though I=99d need a fillet of f
iller to blend it in after fitting it. I double-checked between the paper &
PDF manuals (I=99ve been caught before with differences between the
two) but both have the same dimensions.
Is this something I should worry about? Should I move the slot slightly mor
e towards the centreline to avoid the possibility of it breaking out of the
side of the tunnel?
All input gratefully received.
in friendship
Rowland
| Rowland Carson ... that's Rowland with a 'w' ...
| <rowlandcarson@gmail.com> http://www.rowlandcarson.org.uk
| Skype=2C Twitter: rowland_carson Facebook: Rowland Carson
| pictures: http://picasaweb.google.com/rowlandcarson
|