I'm not aware of a mod ever being requested for this.
If you are building a mono wheel with a tail spring, then this might not
be a great idea as the stern post will carry some of the weight of the
aircraft on the ground.
If on the other hand you are building a tri-gear, then would think that
the stern post will not be subjected to any great loads that low down,
so it shouldn't be a problem. G-IANI is a tri-gear.
Nigel
On 22/11/2014 22:39, spcialeffects wrote:
>
> Hello all. I would like to make an access panel in the stern post in case I
> need
to remove the long control shaft and also to make it easier for access into
the tail end For maintance. My inspector is a bit dubious about cutting into
the post but I said to him that I got the idea after seeing that G-IANI has a
vent from the D panel to the stern post. So my question is, is there a mod for
this install on G-IAN
>
> Attachments:
>
> http://forums.matronics.com//files/image_995.jpg
>
>
|
