Hi vic. I'm in agreement with Pete about the cockpit module. As it was a
separate
moulding needing to be bonded in with measure to to the footwells it may have
been off. I remember using string from the torque tube ends to the middle of
the firewall to make sure there was no sweep of the tube and I then put an
inclinometer
on the tube ends to make sure they were level. Of cause the canoe
sure be level from the start
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=435418#435418
Attachments:
http://forums.matronics.com//files/image_680.jpg
| 