Hi Again
The later Cockpit Modules had a pre-moulded groove in the rear centre tunnel to
accommodate the rear wing pin tie-rod (mod 52).
Does the groove still need to be glassed over as shown in the current build
manual
(chap 27) thus retaining the tie-rod?
I'm thinking that this was only to restore the structural integrity of the rear
tunnel on the earlier cockpit modules and is probably not required on the CM's
with the pre-moulded groove.
Any thoughts?
I would be interested to hear what other builders with the later CM's have done.
--------
Regards
Kelv Weston
Kit 497
kelv@kdweston.biz
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=439136#439136
|