Alain
thank you. Very nice.
How do did you install the plate on the tail control mechanism...must have
been rather difficult.
I am 1.95 and I dont see myself getting into the back of the aircraft to
install the plate!
I was thinking of a similar place for the servo but with a bracket on the
torque tube instead of the plate and control long rod you used. However I
wonder about the integrity of the torque tube as it seems a little thin.
I think that I will have a look at the feasibility of installing something
like your system.
many thanks
Will
William Daniell
LONGPORT
+57 310 295 0744
On Sat, Apr 11, 2015 at 12:05 PM, Alain Chabert <alainchabert@wanadoo.fr>
wrote:
> Hello,
> Look at the solution I adopted from 330 hours and is much simpler than th
e
> proposed mod.
> Regards
>
> *Alain CHABERT*
>
>
> Le 11/04/2015 18:44, William Daniell a =C3=A9crit :
>
> I have seen searching through the list that there are some alternatives
> to the major surgery required for Mod 75 and 76.
>
> For example I saw some correspondence between Raimo and Bob Gowing
> connecting servo to the tail plane torque tube using a bracket. I assume
> that the service is mounted on a fiberglass bracket mounted on the floor
> ....
>
> Could I prevail on anyone who has who has an alternative to the
> official mods and which does not require major surgery send me a pic plea
se.
>
> Many thanks
>
> Will
>
>
> William Daniell
> LONGPORT
> +57 310 295 0744
>
>
|