Gordonthanks for the clarificationIm wondering, where does your sight gauge T
into
the fuel tank vent line?and have you assured yourself that there are no fuel
pockets in possible low points as the sight gauge line snakes towards the fuel
filler which may block the line? From your routing description, Id look for
kinks in or collapsing of your sight gauge line as it (presumably) angles from
the vertical across the flat area of the CM, and into and out of the PAX
headrest.
As I recall, a constrictor in the sight gauge line is required.
Hope this helps,
Fred
> On Apr 23, 2015, at 12:16 PM, GBWFH2010 <gaxuk2001@gmail.com> wrote:
>
>
> Fred,
>
> The sight gauge feed is from the PORT tank.
>
> My use of the word bulkhead was completely wrong, the vertical section sight
gauge tubing is attached to the passenger seat back adjacent to the tunnel.
Sorry
for the confusion.
>
> Gordon
>
> --------
> Gordon Grant
>
> G-BWFH
>
>
>
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=441183#441183
>
>
>
>
>
>
>
>
>
|