Your suspension block is probably different from mine, which was one of the
earliest
and came needing work done by the builder. It was red in colour, solid and
thus needed holes bored through with a hole saw in a drill press. A band saw
was needed to cut out 'V' wedges top and bottom and finally the factory decided
that the block wasn't thick enough, so we had to add in a shim made from a
piece of 1/4" ply board.
Therefore I guess that it's unsurprising that your problems are different.
Still,
you might have been in possession of one of the early blocks if you had bought
an old kit from someone.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=443129#443129
|