I bought this stuff:
http://www.nickstruckparts.com/fuelhose.html
Don't know where to get it in Europe..
Jan de Jong
On 7/27/2015 5:00 PM, Nigel Graham wrote:
> I'm not sure when DIN 73379 was introduced, but it may have been
> before ethanol was incorporated into fuel (and might not therefore
> guarantee compatibility), certainly ethanol does react with some
> synthetic rubbers.
> As a subject that is close to my heart, I have collected some
> informative documents (credits in documents), two of which I attach FYI.
>
> Nigel
>
>
> On 27/07/2015 13:18, JohnFrance wrote:
>>
>> To the experts out there who have knowledge of fuel lines and
>> material quality, I would like your opinion on the following tubing.
>> It is rated at 10 bar, has no internal reinforcing but has a cotton
>> over-braiding. In theory it is more than adequate for the job as I
>> have a pressure regulator limiting to 2.3 psi but I would like to
>> have your ideas on this product please?
>>
>> http://www.advancedfluidsolutions.co.uk/6mm-id-14-cotton-over-braided-nitrile-fuel-hose-pipe-tubing-279-p.asp
>>
>>
>>
>> regards
>> John
>>
>> --------
>> Europa mono Nr 192
>>
>>
>>
>>
>> Read this topic online here:
>>
>> http://forums.matronics.com/viewtopic.php?p=445224#445224
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>>
>
|