Hi All,
I am going back through all of the logs of my aircraft and there is a "Check
Tailplane
Pivot Bearings for Wear" entry, occurring annually. With the compliance
statement as "Wear measured at 0.003" (Limit 0.01")".
There is no SI or SB instruction referenced against it; so I don't know exactly
to what it is referring.
At the last inspection I was advised that this was wear between TP12 and TP11,
and indeed there is a small amount of vertical play in the port tailplane in
that
direction. However nothing that is worrying.
I will probably take out the tailplane soon to install the clamps as SB15
Locitite
doesn't hold for ever; and I am planning to address this play at the same
time.
Best
Jon
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=449870#449870
|