| Subject: | Europa-List: Re: Trim Damper Bolt Length |
|---|---|
| From: | h&jeuropa <butcher43@att.net> |
| Date: | Sun, 2 Oct 2016 04:55:40 |
Graeme, You should not have to trim the M5 bolt. TS03 bellcrank is supported by AN4-15A bolt with two FL14 spacers. The friction assembly attaches to the bellcrank in the hole aft of the bellcrank bearing. Fig 2 page 19-2 shows how the friction assembly is made. The M5 bolt is secured by M5 nyloc and check nuts. Hope this helps. Jim & Heather Read this topic online here: http://forums.matronics.com/viewtopic.php?p=460884#460884 |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Europa-List: Flydat, MikeP |
|---|---|
| Next by Date: | Europa-List: Re: XS parts, Richard Lamprey |
| Previous by Thread: | Europa-List: Flydat, MikeP |
| Next by Thread: | Re: Europa-List: Re: Trim Damper Bolt Length, Graeme Hart |
| Indexes: | [Date] [Thread] [Top] [All Lists] |