Hi All
I'm just applying Mod 56 (Anti-Servo/trim tab drive pin replacement) and
need some advice.
My kit is approx a 1999 vintage and has had a number of previous builders,
one of them did a very nice job of applying what I believe was intended to
be some aerodynamic filling on the trim tab. You can see the remnants of
it in the attached picture.
I had to remove about half of the filler to replace the drive pins.
I couldn't find any instructions in the build manual to fill this area and
wondered if I had missed something in the manual. I'd also like to hear if
others have taken a similar approach.
Thanks
Graeme
[image: 20161016_210457-1.jpg]
|