One more question: last time when we installed the rubber mounts, we managed to
compress not only the MT04's but also the MT03 steel-spacers with which to me
seemed like a reasonable torque, so that I also had to order new MT03's from
Europa.
Although the MT04 should be fully compressed on the MT03 spacers I'd like to
avoid
to again damage the MT03's by overtorquing for obvious reasons.
Any suggestions as to how to make it right? The installation manual only states
"tightened fully":
Note:
The 4 AN5-41 mounting bolts must be tightened fully to compress the rubber
anti-vibration
mounts (MT04) onto the steel spacers (MT03).
Regards
Roland
PH-ZTI
XS TG 914
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=464062#464062
|