Thanks Nigel. A straight in approach it isn't but we will manage.
Mike
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of Nigel Graham
Sent: 19 May 2017 15:53
Subject: Europa-List: Re: engine support
--> <nigel_graham@m-tecque.co.uk>
Mike, you need an 8.0 mm hex. If you need to buy the tool, look for one with
a spherically ground tip - it will allow you to tighten the hex head Allen
bolts from a slight angle (up to about 10 degrees I think) which is useful
if you can't get a "straight in approach" to the little blighters!
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=469435#469435
|