Richard, I have always managed with a drift held in a vice on one side &
hammer & punch other side David Joyce, GXSDJ , N of Stockholm)
On 2017-06-03 09:07, Richard Iddon wrote:
>
> I am replacing the pads on my tri gear. I have got the new pads & rivets from
the factory but it seems I need a rivet squeezer to fit them. I have had a look
on the LAS web site but am confused as to which tool I need. Does anyone have
the correct tool which I could borrow or can I do the job with a hammer & punch?
>
> Richard Iddon
>
> G-RIXS
Links:
------
[1] http://www.matronics.com/Navigator?Europa-List
[2] http://forums.matronics.com
[3] http://wiki.matronics.com
[4] http://www.matronics.com/contribution
|