I'm having some 'U' channel made for my Mono trailer - to extend it and make the
loading/unloading operation easier. Essentially the ramp will be made from
two pieces of 500L x 80D x 225W folded from 6mm Alu plate, hinged so that it
works
as the factory design when loaded but extends the inclined ramp portion to
be 500mm further from the trailer 'hod' the main wheel sits in.
The min qty is 8 pcs and i will use 2 - so i'm wondering if anyone else would
like
to buy the surplus pieces? Cost will be ~60 each. Polyester powder coated
in white as attached drawing.
Any takers/interest?
Clive
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=486893#486893
Attachments:
http://forums.matronics.com//files/aha_b3pd401b_trailer_ramp_177.pdf
|