Hi Pete
If you put a straight edge on the tip and measure along the inside of the
leading
edge (next to the hinges), my rudder measures 48 inches from the straight edge
to the centre of the pushrod bracket.
Similarly, if you put the bottom of the rudder on the floor and measure up the
inside of the leading edge from the floor to the centre of the bracket it is 6
inches.
However, the bracket position is determined by the lower hinge position on the
rudder. If you have that in the right place as shown in Chapter 2 of the Build
Manual, you should be ok.
Hope this helps.
--------
Regards
Kelv Weston
Kit 497
kelv@kdweston.biz
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=487355#487355
|