Thanks Bob
Took a little bit longer to purge the system with the thermostat in line (easily
100 rotations of the prop) before I saw oil coming through the return line and
oil pressure on the gauge but sorted now.
Might be of interest to the group as well but we replaced the mechanical fuel
pump
with the newer rotax one, Ive seen people saying theres been issues with them
not fitting, ours was close but it does fit without touching !
Kind Regards
Eoin
Sent from my iPhone
> On 28 Feb 2019, at 09:28, Bob Harrison <ptag.dev@talktalk.net> wrote:
>
>
> Hi! Eoin,
> For your thermostat to work by sensing the oil temperature there must be a
> small
by pass to allow hot oil to begin to heat the THERMOSTAT for it to begin to
work and allow more hot oil through. Unfortunately the process of purging the
oil cooler matrix will take longer since a considerable amount of oil/air will
need to pass through the small orifice.
> Yes the coolant will need purging but it relies on you starting the engine and
allowing it to cool a few times and topping up the reservoir to level ( assuming
that the cap seals are undamaged and appropriate poundage.)
> I just used my small aircraft tyre inflater to pressure the top of the oil
> tank
to push the air out of the oil cooler but it surprised me how long the process
took to get the air to gurgle through back to the tank whilst turning the
prop. .... and that was after motoring (ignitions OFF ) with an ignition plug
removed from each cylinder on the starter . But there was no doubt the air was
removed by one hell of a gurgle !!!!
>
> Best wishes
> Bob Harrison G-PTAG
>
> -----Original Message-----
> From: owner-europa-list-server@matronics.com
> [mailto:owner-europa-list-server@matronics.com] On Behalf Of Eoin Maguire
> Sent: 28 February 2019 06:59
> To: europa-list@matronics.com
> Subject: Europa-List: Purging oil system / Coolant
>
>
> Hi all
>
> Just after completing the 5 year hose replacement on our Europa and Im just
> wondering
does anyone have answers for the following :
>
> 1. My oil system has a thermostat in line, just wondering when purging as the
oil will be cold am I effectively only purging half the system as it,ll bypass
the oil coolers ? Or is there another method of doing it?
>
> 2. Do I need to purge the coolant system or once I fill with new fluid is that
me done ?
>
> Kind Regards
> Eoin
>
> Sent from my iPad
>
>
>
>
>
> ---
> This email has been checked for viruses by AVG.
> https://www.avg.com
>
>
>
>
>
|