Hi Emmanuel,
The previous advice from Kelvin, Roland and Bob is good. The approved LAA
Modification
can be found here:
http://www.lightaircraftassociation.co.uk/engineering/TADs/247/MOD80.pdf
I sourced my silicon hoses and clamps from this UK outfit:
https://www.merlinmotorsport.co.uk/s?search=Samco+ProFue
However, I found it difficult to tighten the hoses sufficiently to stop a small
amount of fulel seeping out. The solution was to spread a thin layer of Hylomar
blue on the outside of the aluminium tube where it connects with the silicon
tubing, under the clamps. This gives a fuelproof seal to the connection. The
sealant can be found here:
https://www.amazon.co.uk/dp/B0064M6A6G/ref=pe_3187911_189395841_TE_3p_dp_1
Hope this helps
--------
Bob Dawson
Europa XS TG || 912 ULS || G-NHRJ || Dynon Skyview || PilotAware || SmartAss3
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=490664#490664
|