Hi Group
Curiosity question: Can you reuse Binx Nuts for engine mounting? If the answer
is yes, is it recommended to bend the inboard sides of slit steel nuts to close
up slit to get back any lost tension from 1st use?
I see on the Rotax 914 that they use a similar nut for exhaust manifold studs,
only they have 1 slit instead of 2. Same question, can you reuse these? If yes
is it recommended to bend the inboard sides of slit stainless steel nuts to
close
up slit to get back any lost tension from 1st use?
Thx.
Ron P.
Read this topic online here:
http://forums.matronics.com/viewtopic.php?p=491853#491853
|