Hello,
Can anyone tell me what the uncompressed length/height of a new uninstalled MT04
is? I measured the ones I recently removed and they vary considerably and
obviously
have taken a set. I suspect they are something close to .970 or 24.6mm.
As noted in a previous email, I switched to Lord J3608-1 mounts. I contacted
Lord
for the recommended preload, however, they indicated there were too many
variable
to take into consideration. That said, they provided me with a drawing
for the 0-200 motor, which isnt very helpful, I am afraid. Interestingly, I
noted two very distinct differences in the Lord mounts as compared to the MT04s.
First is the hardness, the Lord mounts are quite a bit softer. And the second,
which surprised me, is the uncompressed length/height which I had incorrectly
assumed to be the same the MT04. You know what they say when you assume
something. Anyway the Lord mounts are shorter, by how much I cant say at the
moment as I require the uncompressed dimension of the MT04. Armed with this
information I should be able to trim the space by the delta, which I am hoping
will provide the necessary preload.
Kind regards,
Erich
N28ET Classic Monowheel 914
____________________________________________________________
Sponsored by
https://www.newser.com/?utm_source=part&utm_medium=uol&utm_campaign=rss_taglines_more
Roger Stone Commutation Ups Outrage to Fever Pitch
http://thirdpartyoffers.juno.com/TGL3131/5f09faa73d807aa66ef8st04vuc1
COVID Surge Worries Experts: 'Early Wave of a Lot of Suffering'
http://thirdpartyoffers.juno.com/TGL3131/5f09faa71e7917aa66ef8st04vuc2
Amid Spread of Misinformation, Whispers on FB's Next Move
http://thirdpartyoffers.juno.com/TGL3131/5f09faa73db847aa66ef8st04vuc3
|