*B*rian
since no one else has answered I will attempt to explain.
The bulkhead referred to in the build manual goes in the cockpit module
tunnel. When i built mine I got the "word" from the forum that this was
the thing to do. There are no obvious locating points or hard points.
I cut the bulkhead and adjusted it to fit the tunnel. In my case lacking
the instruction I made the bulkhead in a single piece. I then covered the
edges of the bulkhead in plastic and masking taped the bulkhead in place.
I put 4 ply bid tapes on the top and both sides to form 2" right angle
brackets in the join between the bulkhead and cockpit module. Once cured I
drilled 3/16 holes through both and bolted in place.
Will
William Daniell
LONGPORT
+1 786 878 0246
On Sat, Aug 14, 2021 at 11:17 PM Brian Phillips <barp99@gmail.com> wrote:
> I was browsing the Europa club mod site, and stumbled across this
> trigear cockpit module bulkhead install in the known corrections. I
> can't find any reference to it in the build manual nor hints & tips
> compilation, and the 3mm ply templates do not show the pieces there. I
> can see there are existing stiffeners in the cockpit module I have, see
> photos, but I do not know if these replace or support these bulkheads.
> Does anyone know if these two bulkhead pieces are actually required and
> do they need to be flox sandwiched into place?
>
> Brian Phillips.
>
|