Chriscompliments on both concept and executionWhat
material did you use to make your tool?Would you be willing to
post a couple additional photos?
Thanks,
Fred
A194
> On Aug 28, 2021, at 6:12 PM, n7188u <chmgarb@gmail.com> wrote:
>
<mailto:chmgarb@gmail.com>>
>
> Here is a picture of the tool on the blade. I use a digital level to
level the blade. The laser will shine a spot on the floor and you mark
it. Then do the same for the other blades and match all spots. You end
up with same angle on all blades with great resolution. I tested for
repeatability and it is very good.
> Chris
>
|