I seem to remember an article about this in the Europa Flyer - you might
try the new search facility on the club website. Personally I would be
tempted to run your wires along the wing close outs. You could no doubt
find a suitable three core flat wire and bond it in place and then drill
a hole between your wing tip opening and the outer aileron close out.
Best of luck, David
On 2022-02-17 20:49, Area-51 wrote:
> <goldsteinindustrial@gmail.com>
>
> Thanks David... its a classic; so foam core wing construction.. as far
> as i can tell from construction information the chord ribs are solid; i
> canEUR(tm)t think off anything other than making up a 1/4EUR or
> 3/8EUR bore mounted on a long tube; unless someone knows of an
> allocated area in the factory material for this purpose.
>
> Read this topic online here:
>
> http://forums.matronics.com/viewtopic.php?p=506073#506073
>
|