Hi everybody my name is Pat Tunney and i have started building a Europa Tri-Gear. I want to install a BMW R1100S engine incorporating a Take-Off gearbox and would like to start building a dummy firew
test reply back Pat Tunney Mechanical Engineer Coryton Energy Co Tel 01375 648233 Fax 01375 645302 Mob 07760 172068 e-mail ptunney@intergen.com Hi everybody my name is Pat Tunney and i have started b
Rowland My adaption of Bob Harrison's torque tube clamp has now been approved by the LAA as a standard Mod (11906). The Mod is currently fitted to 1 flying aircraft, 1 ready for test flight and two o
I have measured the cross tube on kit 558 at 44 9/16 bearing to bearing. This is a snug fit between the pins. I remember cutting around an 1/8th of an inch of one or both ends to get the thing to fit
Hi Is there a good product or technique for removing scratches from perspex. Thanks Pat Read this topic online here: http://forums.matronics.com/viewtopic.php?p=365675#365675
All i have had a small batch of clamps machined to a new design. The standard mod will be updated shortly. The attached document details the changes and shows the new clamps prior to machining the bo
I have a couple of pairs of clamps left for any builder or flying aircraft owner who wants to implement SM11906. The image shows what you get on a new install. If you have torque tube with wear in th
Paul i might be interested in sharing costs. I contacted Goldburn earlier in the year to spray the panel and bagage access bay bulkhead. Pat Kit 554 Read this topic online here: http://forums.matroni
I have had some further interest in the clamps. To keep upfront manufacturing costs down i need at least 4 interested builders / flyers. If interested please contact me through e-mail and i can expla
Just another point based on Bob Harrison's message, the clamps that will be supplied are the MK2 style clamps as detailed in LAA Standard Mod SM11906. As always and previously mentioned - i take no c
Hi does anybody have any used or damage surplus wheel leg fairings they would like to part with. Many Thanks Pat Tunney G-SUSE Read this topic online here: http://forums.matronics.com/viewtopic.php?p
I have a set of unused classic cowls and spinner backplate which are free to anybody who wants to collect from the Manchester area. Be quick if your interested as they will be heading to a local tip
I have a spare rear bulkhead as supplied by Europa. If anybody requires one of these components then make me an offer. Pat Tunney Read this topic online here: http://forums.matronics.com/viewtopic.ph
Hello I have a pair of unused wing tip lenses, as supplied by Fred Klein. I no longer require them so if anybody is interested, please make me an offer. Thanks Pat Read this topic online here: http:/
Hi I no longer have the time to support new clamp production. All technical details of the clamps are detailed on the LAA website. Thanks Pat Read this topic online here: http://forums.matronics.com/
Rowland I need a woodcomp controller. I have the prop but no controller. Do you have a private e-mail. Thanks Pat G-SUSE Read this topic online here: http://forums.matronics.com/viewtopic.php?p=45997
Christoph Not sure how you were planning to tackle this job but i would use a pedestal drill or milling machine with the torque tube fully assembled and clamped hard to the machine tool table. Hand d