--- snip ---
Article by Nick Davies:
Metalwork. I'm drawfiling the sides to get rid of the irregularities from
stamping, and sandcleaning the surfaces.
I am finishing a Van's RV-4 (all sluminum) and have been using a
3M Scotchbrite wheel mounted on a bench grinder. This wheel
removes any marks from stamping, cutting, etc. It is quite
efficient. I also use the Scotchbrite pads to clean the
surfaces.
Not sure about a European source, but I purchased mine from Avery
Enterprises, Ft. Worth, TX, USA, hours are 9:00 to 17:30 Central
Time, telephone: 817-439-8400, fax: 817-439-8402
Mike Pilla
pilla@espinc.com
|