I'm constructing a vey simple fuselage dolly from odds and ends.
To stop the fuselage lower moulding sliding around on the dolly when
I move it, I'm thinking of putting a couple of screws through the
bottom of the moulding into the dolly, in the area that is going to
be cut out for the (mono) wheel. Not to clamp it down tight, just to
provide some lateral location.
Anyone see any reason not to to make a couple of holes in what will
eventually become waste?
regards
Rowland
--
| Rowland Carson LAA #16532 http://home.clara.net/rowil/aviation/
| 1030 hours building Europa #435 G-ROWI e-mail <rowil@clara.net>
|