Have you noticed how the flaps/outriggers fall in and out as you move the
wings about ? with danger to limb if not life. Have you also damage your
wing fairings, (as I have twice!). A simple jig can fix both these
possibilities. Make a 5ft by 18" ply board for each wing carrying a hole
for the spar and three stubs or tubes with holes at right angles for the
2 wing pins and flap pin. Trapped onto the spar with the spar pins,(like
a dummy fuselage side) this will a) stop the flap from moving, b) protect
the fairings, and c) enable the wing to be laid in a stable state either
flat or trailing edge down. The latter will be particularly useful for
shaping/spraying the leading edge. Very handy for single-handed
manipulation too.
gemin
|